
Wash off the grime, then pack every joint with sand
Paver Cleaning and Joint Sand in Brandon, FL
Call (656) 254-6231 to have a local contractor wash your Brandon pavers and refill the joints with fresh sand.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can I get my Brandon pavers cleaned without a long wait?
A local contractor cleans pavers across Brandon, FL, and you will hear back inside 1 business day, and often much earlier. Fresh joint sand is part of the job, and the free estimate comes with no pressure to book. To start, call (656) 254-6231.
Cleaning strips off the algae, rust and dirt that dull pavers in this humid corner of Hillsborough County, so the surface looks brighter and grips better underfoot. New sand then goes between the pavers, which steadies them and leaves weeds less space. A walkway that went green over the summer starts to look like part of the yard again. Point out the worst spots when you use the quick estimate form.
Paver Sealing Brandon Is Proud to Serve Tampa Bay

What is part of a paver cleaning job?
The work covers stain treatment, a controlled wash and fresh joint sand once the surface dries. Book it by itself, or treat it as step one of a seal. Damp walkways and the patches by irrigation heads tend to need the most time. To line up a cleaning, call (656) 254-6231.
Stain treatment
A cleaner suited to algae, rust or salt film goes on first and is tried on a small spot.
Controlled wash
A flat surface cleaner covers the area evenly and keeps the pressure suited to the paver.
Fresh joint sand
Polymeric sand is swept into every gap after the pavers dry, then packed down.
Sealer if you want it
Sealer goes on only once the surface is completely dry. The sealing guide covers what it adds.
What are the signs my pavers need cleaning?
Watch for a green or black film along shady edges, orange marks near the sprinklers, weeds in the joints, white patches on newer pavers and sand on the drive after rain. Algae matters most on a walkway or pool deck, because a slick surface can cause a fall. To have yours looked at, call (656) 254-6231.
Is cleaning enough, or should I seal too?
Cleaning restores how pavers look today, and a coat of sealer helps that look last. Stopping at a wash costs less now, yet algae and fading return on their own schedule. A coat makes the next wash simpler, though it has to be renewed every few years. If you want the protective coat as well, say so when you use the quick estimate form.
How often should Brandon pavers be washed?
Most homes do well with a wash about once a year, and shaded paths or spots near sprinklers may want one sooner. A sealed surface stays cleaner between visits. Since the wet months run from June through September, a wash in the fall clears what the summer left. To fit a wash into your yard's calendar, call (656) 254-6231.
Does a harder blast clean pavers better?
No. Unilock says to rinse with the washer on a low setting and to spray at no more than a 30 degree angle, and it warns that the wrong pressure can crack or erode pavers and blow out joint sand. Washy Bear lists 3,000 to 4,000 PSI for driveway pavers but only 500 to 1,000 for pool deck pavers. Ask what pressure the contractor sets when you use the quick estimate form.
Technique counts as much as the machine. A flat surface cleaner held at one height leaves an even finish, and a product chosen for each stain does the heavy lifting in place of force. To ask about the method, call (656) 254-6231.
What are the orange stains near my sprinklers?
Most often they are rust from irrigation water, which leaves orange marks on pavers and concrete. They need a rust treatment, not more pressure, and they must come off before any sealer goes on. Point out the marks when you use the quick estimate form.
Why do newer pavers show white patches?
A chalky white film on newer pavers is usually efflorescence, salts that rise out of the concrete. Unilock says it is typically gone in two to three months and can take up to a year, and that sealing should wait until it clears. A clouded old coat of sealer can pass for it. Point out the patch when you call (656) 254-6231.
How long do pavers need to dry before sealing?
Unilock says pavers in warm sun may be dry in a few hours, while cooler or shaded spots need about 24 hours. Afternoon storms push that out, which is why a wash and a seal often fall on separate days. Ask what happens to the schedule when rain is forecast, once you use the quick estimate form.
Which paved areas can be cleaned at a Brandon home?
Any paved area can be washed, whether driveway, pool deck, patio or front walk. Each collects its own kind of dirt, so the cleaner and the pressure change. To start with yours, use the quick estimate form.
Driveways
Tires, oil drips and hours of direct sun all land on a driveway. Cleaning one keeps the color even and the joints full under the wheel tracks.
Pool decks and lanais
A pool deck stays wet and carries chlorine and bare feet. Cleaning one means choosing a finish that still grips when your feet are wet.
Patios
A patio under a screen or a tree holds moisture, so green growth starts early. Cleaning one begins with the shadiest corners.
Walkways and entries
A front walk sits beside beds, mulch and irrigation heads. Cleaning it is a small job, yet it is where every visitor steps first.
What leaves Brandon pavers dirty?
Sand loss in the rainy months, algae in shade, faded color, old coats and low spots lead the list. A wash handles several of these, while sealing or repairs address the rest. To learn which of these describe your house, call (656) 254-6231.
1. Sand pulled out of the joints
A Brandon sealing company reports that nearly two thirds of the local rain falls from June through September. That water carries joint sand away, and pavers start to shift once the gaps run low.
2. Algae and mildew in shade
The Wikipedia page on Brandon calls the climate humid subtropical, with summers near 85 degrees and about 44 inches of rain a year. Shaded corners and spots by the sprinklers stay damp, and damp is all mildew asks for.
3. Chalky, faded color
Open driveways get sun all day. Unsealed pavers dull first there, and the wash reveals how much of the original shade survived.
4. Worn coats on 1990s subdivision pavers
Brandon reached nearly 58,000 residents by 1990, and a Brandon company says Mason Oaks alone was built from 1988 to 1991, so many homes date from the years after I-75 arrived. Pavers that old may carry more than one old coat, and a new product has to suit what is underneath.
5. Low spots and loose pavers
Unilock notes that sealer cannot cure drainage trouble or a weak base. A paver that rocks under a tire or sits in a puddle needs its base repaired before any coat goes on.
What does paver cleaning cost in Brandon?
Brandon companies publish the full job more often than a wash alone. Washy Bear lists $1.50 to $2.50 per square foot for the wash, joint sand and sealing together, and a wash without the coat should come in under that. Ask for the cleaning and the sand as separate lines, so you can compare bids fairly. For a price on your property, use the quick estimate form.
Planning a coat afterward? Ask for a single combined figure. Rusty's Pro Wash and Seal lists sealing from $1.00 to $1.75 per square foot, and it prices stripping old sealer on its own. For help weighing the two, call (656) 254-6231.
For the protective side, read the sealing guide. The service area list shows coverage, and the home page is where a request begins.
| Paved area | Sealing alone, low listing | Wash, sand and seal |
|---|---|---|
| 400 sq ft | $400 to $700 | $600 to $1,000 |
| 800 sq ft | $800 to $1,400 | $1,200 to $2,000 |
| 1,200 sq ft | $1,200 to $2,100 | $1,800 to $3,000 |
The middle column multiplies the $1.00 to $1.75 per square foot one company lists for sealing in Brandon. The last column uses the $1.50 to $2.50 per square foot another Brandon company lists for the wash, sand and seal together. A wash with sand and no sealer leaves out the coat, so it should land below the last column. Your own quote may fall elsewhere.

Why use a contractor who works near Brandon for paver cleaning?
A contractor who works around Brandon knows what humidity, sprinkler rust and summer storms leave behind. Hold the quote up against the rates posted on this page, and take your time deciding. To begin, use the quick estimate form.
A contractor who knows these streets
A company that already works around Brandon knows the 1990s subdivisions, the HOA rules and the afternoon storms. Your visit starts from that, not from guesses.
A free look, nothing owed
The visit and the written price cost nothing. If the number does not suit you, say no and the matter is closed.
Published prices to hold a bid against
Brandon companies post their own per square foot rates, and this site lists them. A bid far above or below those numbers is worth a question.
You set the pace
Get the price in writing, then take your time with it. Before you sign anything, the contractor standards page shows what to look for.
Want a free estimate to clean your Brandon pavers?
Fill in the quick form or call, and a contractor responds within 1 business day, often earlier.
Free, no obligation

What do cleaned pavers look like around Brandon?








How does the paver cleaning process go, step by step?
If you skip the sealer, the job stops at step four once the joints are filled. To set a date, call (656) 254-6231.
1. Measure and inspect
To price the cleaning job, the contractor measures the paved area and marks dips, loose pavers, old sealer and places where water collects.
2. Protect and wash
Plants and screens are covered and the sprinkler timer is switched off. A flat surface cleaner then washes the pavers in even passes, so the joints are not blasted open.
3. Treat the stains
Rust, algae and white salt film each get a cleaner made for that stain, tried on a small spot first.
4. Refill the joints
After the surface dries, polymeric sand is swept in, packed down and topped off, and the leftover sand is blown clear.
5. Seal and walk it with you
If sealer is on the work order, it goes down by pump sprayer and is smoothed with a roller. Then the contractor walks the area with you and says when feet and tires can return.
Frequently Asked Questions
What should I clean pavers with before sealing?
A cleaner matched to the stain, followed by a rinse. Washy Bear lists stain extraction as its own step before sealing, and another Brandon company uses pressure washing with cleaners plus a pH-neutral product on natural stone, never acid. Rust, algae and white salt film each want something different.
How much does it cost to get pavers cleaned?
A cleaning-only rate is hard to find, because Brandon companies publish the full job. Washy Bear lists $1.50 to $2.50 per square foot for the wash, joint sand and sealing together. Leaving the sealer out should cost less, so ask for the wash and sand priced on their own line.
Can I clean pavers with Dawn dish soap?
Dish soap may lift light grime, but it does not treat algae roots, rust or salt film, and any film it leaves must be rinsed off before sand or sealer goes down. A contractor picks a cleaner for the actual stain, so ask what they plan to use on yours.
Is it a good idea to pressure wash pavers?
Yes, with the washer set low. Unilock says to spray at no more than a 30 degree angle so the joint material stays put, and it warns that wrong settings can crack or erode pavers and blow out sand. Washy Bear lists 3,000 to 4,000 PSI for driveway pavers with a flat surface cleaner.
Is there a downside to sealing pavers?
The main one is repeat cost, since a coat lasts roughly two to four years in Brandon. Unilock adds that trapped moisture or too much sealer can leave a whitish film. Cleaning alone avoids those risks, but it adds no protection.
How often do you need to reseal pavers in Florida?
Every two to four years is typical. A Brandon company says a coat lasts two to four years and suggests resealing every two to three. Washing in between keeps the surface looking even, since algae returns faster in shade.
Why do my Brandon pavers keep turning green?
Shade, humidity and sprinklers keep the surface damp. Brandon sits in a humid subtropical climate with about 44 inches of rain a year, and nearly two thirds of it falls from June through September. Less overspray from the irrigation and a sealed surface both slow the return.
What pressure is safe for a Brandon pool deck?
Lower than a driveway. Washy Bear lists 500 to 1,000 PSI for pool deck pavers, against 3,000 to 4,000 for driveway pavers and 1,000 to 2,000 for open joints. Ask what pressure the contractor sets for each area.
Ready for clean, even pavers again?
Reach out by phone or the short form, and a contractor responds inside 1 business day, and often within hours.
Free, no obligation
