Click To Call(656) 254-6231Click To Get A Free Estimate
Brick paver driveway sealed to a rich color in front of a Brandon home with palms

Deeper color, packed joints and an easier clean

Paver Sealing in Brandon, FL

Call (656) 254-6231 and a local contractor will price sealing for your Brandon driveway, pool deck or walkway.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.50 to $2.50 a sq ft to clean, sand and seal
Call Now(656) 254-6231

Who can seal pavers at my Brandon home?

A local contractor seals pavers throughout Brandon, FL, and you will hear back inside 1 business day, and often much earlier. The estimate is free, and booking is up to you. To begin, call (656) 254-6231.

Sealing deepens the color of your pavers, holds the joint sand where it belongs and makes dirt easier to rinse off. Picture the driveway after a humid summer, gray at the edges and sandy at the seams, turned rich and even again. A drive takes tires and oil drips and a pool deck takes splash and bare feet, so each area gets its own plan. When you use the quick estimate form, mention how your family uses each one.

Call (656) 254-6231

Two contractors sealing a paver driveway, one rolling and one spraying
What's included

What is included when pavers are sealed in Brandon?

A sealing job has four parts: an inspection, a deep wash, fresh joint sand and the sealer coat. Washing usually takes the longest. To walk through every part for your own house, call (656) 254-6231.

Walk-through

The contractor notes the size, low spots, cracked pavers, old sealer and any pooling water before naming a price.

Deep wash

Algae, rust and dirt come off with a flat surface cleaner and a cleaner matched to the stain.

Joint sand

Polymeric sand fills each gap, which ties the pavers together and leaves weeds less room.

Sealer coat

Sealer goes onto dry pavers by sprayer and roller, at the coverage the label calls for.

How can I tell my pavers need sealing?

Look for chalky color, joints that sit below the paver edges, sand scattered on the drive after a storm and water that sinks in instead of beading. Adding sand while the gaps are shallow costs less than relaying pavers that have shifted. For a quick opinion, call (656) 254-6231.

Which sealer works in Brandon's humidity?

No product suits every house, so ask which sealer the contractor plans to use and why. Washy Bear lists a breathable clear coat for a natural matte look and a high solids wet look acrylic. Rusty's Pro Wash and Seal lists a water-based acrylic urethane in four finishes. To compare options for your pavers, call (656) 254-6231.

Unilock says water-based sealer cleans up easily and hardens joint sand, while solvent-based sealer is a little more durable but needs pavers and joints that are perfectly dry. Solvent products also evaporate faster, so cooler weather suits them. Ask which one goes where when you use the quick estimate form.

Should I pick a wet look or a natural finish?

A wet look gives deep color with a sheen, and a natural finish stays near the original paver. Unilock says a wet look deepens color but may be slippery when wet, while a penetrating matte keeps texture and traction. By a pool, grip matters more than shine. To see both on a sample, use the quick estimate form.

How long does paver sealer last in Brandon?

Expect two to four years. A Brandon sealing company puts a coat at two to four years here and suggests resealing every two to three, and Unilock says many owners reapply every three to five. A driveway in full sun wears out sooner than a covered patio. If a splash sinks in rather than beading, the coat has run its course. To have it checked, call (656) 254-6231.

Do extra coats of sealer give more protection?

No. Unilock says to seal in one go, since layers laid over the same spot cause gloss differences, and it links an uneven or heavy coat to a whitish film and lap marks. The target is a single even coat spread at the rate on the label. If a bid pushes three or four coats as extra armor, ask why before you use the quick estimate form.

When is the right time to seal pavers in Brandon?

Watch the forecast more than the calendar. Unilock asks for clear skies for 24 to 48 hours before sealing and up to 48 hours of dry weather after, in a range of about 50 to 90 degrees with 75 ideal. Pavers baked by the sun can stain or peel. Since nearly two thirds of Brandon rain falls from June through September, many owners aim for the drier months. To lock in a day when the sky is clear, call (656) 254-6231.

New pavers must wait. Unilock says to hold off until the white salt haze called efflorescence has cleared, which is typically two to three months and can reach a year, and it gives 60 to 90 days for new installs. Newly laid pavers? Give the install date when you use the quick estimate form.

Can sealing fix sunken or loose pavers?

No. Unilock says sealing does not cure poor drainage or a faulty base, so a paver that rocks or a spot that holds water needs repair first. Joint sand only stays on a level surface. Check whether leveling sits inside the price or is a separate line when you use the quick estimate form.

Surfaces

Which areas around a Brandon home can be sealed?

The same coat works on a drive, a pool apron, a back patio or a front path. Every surface wears differently, so each one gets its own plan. To start where the problem is worst, use the quick estimate form.

Driveways

Tires, oil drips and hours of direct sun all land on a driveway. Sealing one keeps the color even and the joints full under the wheel tracks.

Pool decks and lanais

A pool deck stays wet and carries chlorine and bare feet. Sealing one means choosing a finish that still grips when your feet are wet.

Patios

A patio under a screen or a tree holds moisture, so green growth starts early. Sealing one begins with the shadiest corners.

Walkways and entries

A front walk sits beside beds, mulch and irrigation heads. Sealing it is a small job, yet it is where every visitor steps first.

Common problems

What causes paver trouble in Brandon?

Five problems come up again and again around Brandon: sand loss in the rainy months, algae in shade, faded color, worn coats on older subdivision pavers and low spots. Each is cheaper to handle early. To learn which of these fit your pavers, call (656) 254-6231.

1. Sand pulled out of the joints

A Brandon sealing company reports that nearly two thirds of the local rain falls from June through September. That water carries joint sand away, and pavers start to shift once the gaps run low.

2. Algae and mildew in shade

The Wikipedia page on Brandon calls the climate humid subtropical, with summers near 85 degrees and about 44 inches of rain a year. Shaded corners and spots by the sprinklers stay damp, and damp is all mildew asks for.

3. Chalky, faded color

Open driveways get sun all day. Unsealed pavers dull first there, and a coat that is two to four years old has often given up what protection it had.

4. Worn coats on 1990s subdivision pavers

Brandon reached nearly 58,000 residents by 1990, and a Brandon company says Mason Oaks alone was built from 1988 to 1991, so many homes date from the years after I-75 arrived. Pavers that old may carry more than one old coat, and a new product has to suit what is underneath.

5. Low spots and loose pavers

Unilock notes that sealer cannot cure drainage trouble or a weak base. A paver that rocks under a tire or sits in a puddle needs its base repaired before any coat goes on.

Pricing

What does paver sealing cost in Brandon?

Expect about $1.50 to $2.50 per square foot for the wash, sand and seal together, the range Washy Bear lists on its Brandon page. Rusty's Pro Wash and Seal lists sealing alone from $1.00 to $1.75, and it prices stripping old sealer separately. Failed old coats are removed first, and that adds cost. For a number written for your home, use the quick estimate form.

Size matters on a big lot. A 1,500 square foot driveway plus pool deck at that range runs about $2,250 to $3,750. A quote far below the rest may skip steps, so ask what it leaves out. If you already hold a bid, call (656) 254-6231 and compare it with these figures.

A wash alone is covered on the paver cleaning and joint sand page. To see which towns get service, open the service area list, or head back to the home page.

Paved areaTypical exampleClean, sand and seal
300 sq ftSmall patio or walkway$450 to $750
600 sq ftTwo car driveway$900 to $1,500
1,000 sq ftLarge driveway or pool deck$1,500 to $2,500
1,500 sq ftDriveway plus pool deck$2,250 to $3,750

Math based on the $1.50 to $2.50 per square foot that Tampa Bay paver companies publish. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.

Get a Free Estimate

Screened pool with sealed paver decking and a palm in a planter
Why choose us

Why hire a contractor who works near Brandon?

A contractor who works around Brandon plans for summer downpours, association rules and pavers that are a few decades old. Expect the price on paper; whether to hire is for you to decide. To begin, call (656) 254-6231.

A contractor who knows these streets

A company that already works around Brandon knows the 1990s subdivisions, the HOA rules and the afternoon storms. Your visit starts from that, not from guesses.

A free look, nothing owed

The visit and the written price cost nothing. If the number does not suit you, say no and the matter is closed.

Published prices to hold a bid against

Brandon companies post their own per square foot rates, and this site lists them. A bid far above or below those numbers is worth a question.

You set the pace

Get the price in writing, then take your time with it. Before you sign anything, the contractor standards page shows what to look for.

Ready for a free paver sealing estimate in Brandon?

Call or send the short form, and a reply comes inside 1 business day, often long before.

Call (656) 254-6231

Free, no obligation

Broom sweeping joint sand across clean pavers beside a darker, dirty section
Photos

How do Brandon pavers look after a fresh seal?

Freshly sealed paver driveway at a Brandon area home
Sealed paver pool deck at a Brandon area home
Sealed paver patio behind the home at a Brandon area home
Sealed paver walkway to a front door at a Brandon area home
Close view of freshly sealed pavers at a Brandon area home
Paver area with one cleaned half beside a dirty half at a Brandon area home
Contractor cleaning pavers at a Brandon area home
Contractor sealing or sanding pavers at a Brandon area home
How it works

How does the paver sealing process work from start to finish?

Nearly every job follows five steps, from the first inspection to a closing walk-through. If you are ready to schedule, call (656) 254-6231.

1. Measure and inspect

To price the sealing job, the contractor measures the paved area and marks dips, loose pavers, old sealer and places where water collects.

2. Protect and wash

Plants and screens are covered and the sprinkler timer is switched off. A flat surface cleaner then washes the pavers in even passes, so the joints are not blasted open.

3. Treat the stains

Rust, algae and white salt film each get a cleaner made for that stain, tried on a small spot first.

4. Refill the joints

After the surface dries, polymeric sand is swept in, packed down and topped off, and the leftover sand is blown clear.

5. Seal and walk it with you

If sealer is on the work order, it goes down by pump sprayer and is smoothed with a roller. Then the contractor walks the area with you and says when feet and tires can return.

Questions

Frequently Asked Questions

How often should I seal pavers in Florida?

Every two to four years is the usual answer. A Brandon sealing company says a coat lasts two to four years here and suggests resealing every two to three. Unilock, which makes pavers, reports that many owners recoat every three to five years. Sun, sprinklers and car traffic push the number down.

What is the average cost to seal pavers in Florida?

Washy Bear, a company with a Brandon page, lists $1.50 to $2.50 per square foot for a deep wash, joint sand and sealing. Rusty's Pro Wash and Seal lists sealing alone from $1.00 to $1.75. Stripping old sealer and tinting are usually priced separately.

Which sealer works best for pavers in Florida?

No single product wins everywhere. Unilock prefers water-based sealers because they clean up easily and harden joint sand, and it calls solvent-based ones a little more durable but fussier about dryness. A Brandon company uses breathable urethane on brick and a penetrating sealer on travertine, so match the product to the stone.

How can I seal the gaps between my pavers?

Fill them with polymeric sand after the surface is washed and dry, then sweep, pack and settle it. Washy Bear lists that step before the sealer. Unilock adds that a sealed top layer leaves fewer places for windblown seeds to take hold.

Is there a downside to sealing pavers?

The main costs are repeat visits and a few finish risks. Unilock says trapped moisture or too much sealer can leave a whitish film, and a high gloss coat can be slippery when wet. A matte finish keeps more traction.

How long should I stay off pavers after sealing in Brandon?

Count on roughly 24 hours for foot traffic and 48 for vehicles. Washy Bear and another Brandon sealing company both give 24 hours for foot traffic and about 48 for vehicles. Keep the sprinklers off during that time, since Unilock says water can leave white marks.

Does sealing change the color of my Brandon pavers?

It can. Unilock says a wet look finish deepens color, while a penetrating matte keeps the original look. Rusty's Pro Wash and Seal also lists semi-transparent tints in 12 colors for pavers that have faded.

Can a Brandon pool deck be sealed without making it slippery?

Often yes. A Brandon company offers a non-slip additive for areas that stay wet, and Unilock says high gloss may increase slipperiness. Ask which product and finish the contractor would use around your pool.

Will my Brandon HOA need to approve a new paver finish?

Check your documents, because many subdivisions have architectural rules. A natural finish that matches the existing color is the least likely to raise questions, while a gloss or tint may need a quick look from the board.

Time to protect your Brandon pavers?

Either a short request or a phone call brings a reply from a contractor, within 1 business day, often within hours.

Call (656) 254-6231

Free, no obligation